September 30, 2018

BeSafe has developed their seats with much care, to protect your child during the first phase of her or his life. It is important that you read this guidelines BEFORE installing your base/seat. Incorrect installation could endanger your child.

 ISOfix installation

 It is NOT ALLOWED to mount the seat in a front passenger seat WITH AN ACTIVATED AIRBAG. When installed with ISOfix: Make sure the indicators
are green before you drive. The floor support must always be used. Make sure that the floor support is fully pushed down.

Step 1: The insertion clips make the installation easier. Click the insertion clips onto the ISOfix anchorage points on the vehicle seat (between seat and backrest). The insertion clips should be removed when not in use. 

Step 2: Release the floor support from underneath the base. Do this outside the car.

Step 3: Position the base on the car seat. Click the ISOfix connectors in the ISOfix points on the vehicle seat. Make sure that both ISOfix indicators are green.

Step 4: Push the ISOfix release handle down in the base. Push the ISOfix base as far as possible towards the backrest of the vehicle seat.

Step 5: Unlock the height adjuster floor support and push the floor support down till it’s in contact with the floor of the car.

Step 6: Unlock the height adjuster floor support and push the floor support down till it’s in contact with the floor of the car. Always check if the ISOfix indicators are green, before positioning the seat on the base

Step 7: Position the iZi Go on the base. Check if the seat is fixed to the base and if the seat release indicators of the release handle indicate green. If the indicators do not indicate green, check if the seat is fixed in the right way. Leave the carrying handle of the seat in the vertical position carrying position while driving.

 Here is a simple video tutorial, to help you better understand how to install it in your car. Although the theoretical part may be massive, the installation is easy as pie and you can do it in less than 5 minutes. :)

 

Removing iZi Go ISOfix

Step 1: Remove the iZi Go while pressing down the seat release handle at the front side of the base.

Step 2:To release the ISOfix anchorages, pull the ISOfix release handle backwards totally. After release the indicators should show a red indication.

Step 3: Push the ISOfix release handle down. Push the ISOfix anchorages totally inside the base.

Step 4: Unlock the height adjuster of the floor support and push the floor support fully up. 

Step 5: Take the iZi Go ISOfix base out of the car.

Step 6: Store the floor support underneath the base .

Step 7: Remove the ISOfix insertion clips from the vehicle seat and store them underneath the base.

 

Vital information 

It is NOT ALLOWED to mount the seat in a front passenger seat WITH AN ACTIVATED AIRBAG.

  • iZi Go ISOfix can only be installed rearward-facing with the ISOfix anchorage in a car equipped with ISOfix anchorage points.
  • iZi Go ISOfix is approved in group 0+, rearward-facing from 0-13 kg. 
  • The floor support must always be used. Make sure that the floor support is fully pushed down. 
  • The child must always be secured with the internal harness straps when seated in the child seat. The same applies to carrying the seat and when using in combination with a stroller.
  • When installed with ISOfix: Make sure the indicators are green before you drive.
  • When the child weighs over 13 kg or the shoulder height grows above the highest position of the shoulder straps, the child must change to a group 1 seat.
  • After an accident, the seat must be replaced. Although it may look undamaged, if you were to have another accident, the seat may not be able to protect your child as well as it should

 

Hope this was helpful!

Loads of love,

Bump To Baby xxx